How to choose Freshome Formaldehyde Removal?

Be it pre-renovation or post-renovation, our products have something to offer.

For pre-renovation, use our products to prevent from renovating your house into a toxic home polluted with high formaldehyde concentration. This can be achieve by coating our products on engineered woods, and transforming it into Super Low Formaldehyde Emission standard, which is healthier and suitable for indoor usage.

For post-renovation, our products can effectively treat and remove high formaldehyde concentration in your newly renovated home and office. On top of coating on engineered wood, we offer wide range of products to be coated on ceiling and curtain.

The following are types of product category:

Product Efficacy

Our products efficacy were evaluate by independent organisation in Malaysia.

By comparison, normal plywood has very high formaldehyde emission. On average, the reading is around 13mg/L. (higher than max. value of F☆ plywood at 7.0 mg/L, and not recommended for indoor usage)

Whereas the plywood coated with Freshome Formaldehyde Adsorbent has detected a super low formaldehyde emission standard, with the average reading of below 0.1mg/L. (lower than max value of F☆ ☆ ☆ ☆ at 0.4mg/L)

Method of Application :

1) Pour liquid into tray cup.

2) Soak the brush/paint roller with the liquid.

3) Coating on un-finished wood surface.

💯 For best result and cost effective, start coating on engineered woods after raw sheet material (plywood, block-board, etc.) were cut into size.

Ceiling of your home may not be the source of formaldehyde emission. However, you can transform the ceiling surface into functional surface which works continuously to adsorb and decompose air borne formaldehyde gas in the indoor.

Continuous decomposition of air-borne formaldehyde gas effectively lower the concentration.

Product Efficacy

Test result shows our product effectively reducing indoor formaldehyde concentration by almost 50%, by coating on the ceiling area. The reduction performance test was evaluated by JIS A1905-1 / ISO 16000-23.

Method of Application :

1) Pour liquid into tray cup.

2) Soak the coating sponge/paint roller with the liquid.

3) Coating on ceiling.

A safe and secure transparent liquid.

Spray on curtain material to adsorb and decompose formaldehyde emission from the curtain itself.

In addition, it also transformed your curtain into a functional surface and helps to reduce indoor formaldehyde concentration through the decomposition of airborne formaldehyde.

Method of Application

1. Spray at a distance of 30 cm from curtains.

2. Approximately 9 full sprays per 1 m².